Micro-Gro is a blend of growth hormones extracted from plant material that will enhance plant performance, photosynthesis and general health by triggering the plants built-in natural immune system. One very important ingredient is tricontanol, a powerful plant growth regulator. Micro-Gro is very high in vitamins, plus other valuable minerals. It also includes sugars, starches, proteins, fibre and 16 amino acids. Fermented to retain all the nutrients and minerals, Micro-Gro is used during the active growth stage via foliar spray.

Airborne diseases spread from plant to plant by wind, rain, and insects. Micro-Gro can significantly improve the plant's ability to fend off these disease sectors by reducing the space and moisture available to the pathogens on the plant surface. Improved crop sizing, consistency, post-harvest shelf life, colour, flavour, and density are all benefits of foliar treatments. Results will vary depending on the crop. Spraying crops with Micro-Grow on a regular basis will improve overall crop quality during harvest and maintain quality during storage and pack-out.

Micro-Gro is not a pesticide and does not contain chemicals that could be construed as such. The microbes in this product function as a biological control measure in suppressing and or controlling pests through the introduction of beneficial microorganisms to the plant environment. Therefore pests and pathogens are suppressed through natural processes by increasing the competitive and antagonistic activities if the microorganisms in Micro-Gro.

Foliar Treatments:
Apply Micro-Gro with a boomsprayer at a 1:500 Micro-Grow /water dilution rate. Application should begin at early tillering for broadacre crops and applied again depending on conditions and objectives. Approximately 2.5 – 5 litres/hectare of Micro-Gro should be applied during a foliar treatment. If spray rate is less than 100 litres per hectare then more Micro-Gro is needed for desired results a lower dilution rate, 1:250, may be necessary. Treat a smaller test plot with the lower dilution rate and monitor the crop response for 24-48 hours before treating the entire crop.